Quicksilver M60 Manual do Utilizador descarregar pdf

Quicksilver Audio M60 Mono Amplifier

Operating Instructions

Thank you for purchasing the Quicksilver Audio M60 Mono Amplifiers. The amplifiers have been engineered to have

a wide bandwidth, low distortion and excellent dynamic range.

Quicksilver believes simplicity provides the best sound and reliability. The AC signal in the M60 travels through only

one input tube, one driver tube, one coupling capacitor, the output tube and the output transformer. With only five

devices in the signal path, very little coloration is imparted to the signal.

This is an all tube design and uses no circuit boards or transistors.

PLACEMENT

The M60 Mono Amplifiers should be placed where they will have plenty of air circulation. Allow

at least 6 inches of ventilation space on either side and at least 10 inches above them.

SPEAKER CONNECTION

Screw terminals are used for speaker connection because of their superior sonic performance.

The output transformer wires are silver soldered directly to the screw strips eliminating any output

wiring. Placing the amp directly behind the speaker with a very short speaker wire will further

improve the performance. The connection to the 4 or 8 ohm tap will be determined by the rating

on the back of your speaker system. The 1 ohm tap is for special applications only. The C terminal

should be connected to the common, ground, or negative terminal of your speaker.

SYSTEM GROUNDING

Your Mono Amplifiers come with three pronged grounded AC plugs. In some systems, where the

preamp is also grounded, a ground loop may appear as a low level hum. Using an adaptor on the

AC plug, to lift the ground, will solve this problem.

Input

100K

C 1 4 8

This device has very high internal voltages. Never operate with the bottom removed!

Never operate your amplifers with the speakers disconnected.

To prolong the life of your amplifiers, never turn them on and off within a short period of time

(45 seconds.)

1 2 3

Quicksilver Audio M60 Mono AmplifierOperating InstructionsThank you for purchasing the Quicksilver Audio M60 Mono Amplifiers. The amplifiers have bee

2 AMP SLO-BLO FUSEStandard fuse value must not be exceeded. If a fuse blows, replace and turn amp back on. Visuallyinspect all 4 output tubes to see

Quicksilver Audio M60 Mono AmplifiersSPECIFICATIONSPower Output 60 watts into 4 or 8 ohmsPower Bandwidth 15 Hz to 50 KHzPeak Power 100 watts (8 ohm

Sem comentários

Quicksilver M60 Manual do Utilizador